SPM: Partial implementation of PSA interrupt control APIs
This patch implements two of the Secure Partition APIs for
interrupt control defined by FF-M v1.1:
- psa_irq_enable
- psa_irq_disable
Implement only these two for SLIH for the time being.
Change-Id: Ia1103b2d70f1406e2ad0100d856f9e11568c2430
Signed-off-by: Kevin Peng <kevin.peng@arm.com>
diff --git a/interface/include/psa/service.h b/interface/include/psa/service.h
index 94eb082..8cd6556 100644
--- a/interface/include/psa/service.h
+++ b/interface/include/psa/service.h
@@ -1,5 +1,5 @@
/*
- * Copyright (c) 2018-2019, Arm Limited. All rights reserved.
+ * Copyright (c) 2018-2021, Arm Limited. All rights reserved.
*
* SPDX-License-Identifier: BSD-3-Clause
*
@@ -49,6 +49,9 @@
/* Store a set of one or more Secure Partition signals */
typedef uint32_t psa_signal_t;
+/* A type used to temporarily store a previous interrupt state. */
+typedef uint32_t psa_irq_status_t;
+
/**
* Describe a message received by an RoT Service after calling \ref psa_get().
*/
@@ -260,6 +263,40 @@
*/
void psa_panic(void);
+/**
+ * \brief Enable an interrupt.
+ *
+ * \param[in] irq_signal The signal for the interrupt to be enabled.
+ * This must have a single bit set, which must be the
+ * signal value for an interrupt in the calling Secure
+ * Partition.
+ *
+ * \retval void
+ * \retval "PROGRAMMER ERROR" If one or more of the following are true:
+ * \ref irq_signal is not an interrupt signal.
+ * \ref irq_signal indicates more than one signal.
+ */
+void psa_irq_enable(psa_signal_t irq_signal);
+
+/**
+ * \brief Disable an interrupt and return the status of the interrupt prior to
+ * being disabled by this call.
+ *
+ * \param[in] irq_signal The signal for the interrupt to be disabled.
+ * This must have a single bit set, which must be the
+ * signal value for an interrupt in the calling Secure
+ * Partition.
+ *
+ * \retval 0 The interrupt was disabled prior to this call.
+ * 1 The interrupt was enabled prior to this call.
+ * \retval "PROGRAMMER ERROR" If one or more of the following are true:
+ * \ref irq_signal is not an interrupt signal.
+ * \ref irq_signal indicates more than one signal.
+ *
+ * \note The current implementation always return 1. Do not use the return.
+ */
+psa_irq_status_t psa_irq_disable(psa_signal_t irq_signal);
+
#ifdef __cplusplus
}
#endif