feat(imx8ulp): ddrc switch auto low power and software interface
Enable switch between DDRC Auto low power and software/hardware
control modes DDRC Auto low-power mode is used when system is
active, software/hardware control mode is used when going into
suspend. Enable switching between Auto mode and SW/HW mode in
enter/exit retention routines.
Set LPI_SRPD_LONG_MCCLK_GATE_WAKEUP_F2 Max setting to allow
LPDDR_EN_CLKGATE reload LPI_SRPD_LONG_MCCLK_GATE_WAKEUP_F2 to
exit retention mode
Signed-off-by: Pascal Mareau <pascal.mareau@nxp.com>
Signed-off-by: Adrian Alonso <adrian.alonso@nxp.com>
Signed-off-by: Hongting Ting <hongting.dong@nxp.com>
Signed-off-by: Jacky Bai <ping.bai@nxp.com>
Change-Id: I3c4b6f7bc6ca02649ff27cd3d9a0c50dab3a3ad0
diff --git a/plat/imx/imx8ulp/imx8ulp_bl31_setup.c b/plat/imx/imx8ulp/imx8ulp_bl31_setup.c
index a89a110..696f4b6 100644
--- a/plat/imx/imx8ulp/imx8ulp_bl31_setup.c
+++ b/plat/imx/imx8ulp/imx8ulp_bl31_setup.c
@@ -39,8 +39,8 @@
#define TRUSTY_PARAMS_LEN_BYTES (4096*2)
static const mmap_region_t imx_mmap[] = {
- DEVICE0_MAP, DEVICE1_MAP, ELE_MAP,
- SEC_SIM_MAP, SRAM0_MAP,
+ DEVICE0_MAP, DEVICE1_MAP, DEVICE2_MAP,
+ ELE_MAP, SEC_SIM_MAP, SRAM0_MAP,
{0}
};