diff --git a/include/drivers/st/bsec.h b/include/drivers/st/bsec.h
index d833e7a..60dcf3c 100644
--- a/include/drivers/st/bsec.h
+++ b/include/drivers/st/bsec.h
@@ -1,5 +1,5 @@
 /*
- * Copyright (c) 2017-2019, STMicroelectronics - All Rights Reserved
+ * Copyright (c) 2017-2022, STMicroelectronics - All Rights Reserved
  *
  * SPDX-License-Identifier: BSD-3-Clause
  */
@@ -19,13 +19,6 @@
 #define BSEC_OTP_BANK_SHIFT		5
 #define BSEC_TIMEOUT_VALUE		0xFFFF
 
-#define ADDR_LOWER_OTP_PERLOCK_SHIFT	0x03
-#define DATA_LOWER_OTP_PERLOCK_BIT	0x03U /* 2 significants bits are used */
-#define DATA_LOWER_OTP_PERLOCK_MASK	GENMASK(2, 0)
-#define ADDR_UPPER_OTP_PERLOCK_SHIFT	0x04
-#define DATA_UPPER_OTP_PERLOCK_BIT	0x01U /* 1 significants bits are used */
-#define DATA_UPPER_OTP_PERLOCK_MASK	GENMASK(3, 0)
-
 /*
  * Return status
  */
@@ -35,110 +28,34 @@
 #define BSEC_INVALID_PARAM		0xFFFFFFFCU
 #define BSEC_PROG_FAIL			0xFFFFFFFBU
 #define BSEC_LOCK_FAIL			0xFFFFFFFAU
-#define BSEC_WRITE_FAIL			0xFFFFFFF9U
-#define BSEC_SHADOW_FAIL		0xFFFFFFF8U
-#define BSEC_TIMEOUT			0xFFFFFFF7U
+#define BSEC_TIMEOUT			0xFFFFFFF9U
+#define BSEC_RETRY			0xFFFFFFF8U
+#define BSEC_NOT_SUPPORTED		0xFFFFFFF7U
+#define BSEC_WRITE_LOCKED		0xFFFFFFF6U
+#define BSEC_ERROR_INVALID_FVR		0xFFFFFFF5U
 
 /*
- * BSEC REGISTER OFFSET (base relative)
+ * OTP MODE
  */
-#define BSEC_OTP_CONF_OFF		0x000U
-#define BSEC_OTP_CTRL_OFF		0x004U
-#define BSEC_OTP_WRDATA_OFF		0x008U
-#define BSEC_OTP_STATUS_OFF		0x00CU
-#define BSEC_OTP_LOCK_OFF		0x010U
-#define BSEC_DEN_OFF			0x014U
-#define BSEC_DISTURBED_OFF		0x01CU
-#define BSEC_DISTURBED1_OFF		0x020U
-#define BSEC_DISTURBED2_OFF		0x024U
-#define BSEC_ERROR_OFF			0x034U
-#define BSEC_ERROR1_OFF			0x038U
-#define BSEC_ERROR2_OFF			0x03CU
-#define BSEC_WRLOCK_OFF			0x04CU /* Safmem permanent lock */
-#define BSEC_WRLOCK1_OFF		0x050U
-#define BSEC_WRLOCK2_OFF		0x054U
-#define BSEC_SPLOCK_OFF			0x064U /* Program safmem sticky lock */
-#define BSEC_SPLOCK1_OFF		0x068U
-#define BSEC_SPLOCK2_OFF		0x06CU
-#define BSEC_SWLOCK_OFF			0x07CU /* Write in OTP sticky lock */
-#define BSEC_SWLOCK1_OFF		0x080U
-#define BSEC_SWLOCK2_OFF		0x084U
-#define BSEC_SRLOCK_OFF			0x094U /* Shadowing sticky lock */
-#define BSEC_SRLOCK1_OFF		0x098U
-#define BSEC_SRLOCK2_OFF		0x09CU
-#define BSEC_JTAG_IN_OFF		0x0ACU
-#define BSEC_JTAG_OUT_OFF		0x0B0U
-#define BSEC_SCRATCH_OFF		0x0B4U
-#define BSEC_OTP_DATA_OFF		0x200U
-#define BSEC_IPHW_CFG_OFF		0xFF0U
-#define BSEC_IPVR_OFF			0xFF4U
-#define BSEC_IP_ID_OFF			0xFF8U
-#define BSEC_IP_MAGIC_ID_OFF		0xFFCU
+#define BSEC_MODE_OPEN1			0x00U
+#define BSEC_MODE_SECURED		0x01U
+#define BSEC_MODE_OPEN2			0x02U
+#define BSEC_MODE_INVALID		0x04U
 
 /*
- * BSEC_CONFIGURATION Register
- */
-#define BSEC_CONF_POWER_UP_MASK		BIT(0)
-#define BSEC_CONF_POWER_UP_SHIFT	0
-#define BSEC_CONF_FRQ_MASK		GENMASK(2, 1)
-#define BSEC_CONF_FRQ_SHIFT		1
-#define BSEC_CONF_PRG_WIDTH_MASK	GENMASK(6, 3)
-#define BSEC_CONF_PRG_WIDTH_SHIFT	3
-#define BSEC_CONF_TREAD_MASK		GENMASK(8, 7)
-#define BSEC_CONF_TREAD_SHIFT		7
-
-/*
- * BSEC_CONTROL Register
- */
-#define BSEC_READ			0x000U
-#define BSEC_WRITE			0x100U
-#define BSEC_LOCK			0x200U
-
-/*
- * BSEC_OTP_LOCK register
- */
-#define UPPER_OTP_LOCK_MASK		BIT(0)
-#define UPPER_OTP_LOCK_SHIFT		0
-#define DENREG_LOCK_MASK		BIT(2)
-#define DENREG_LOCK_SHIFT		2
-#define GPLOCK_LOCK_MASK		BIT(4)
-#define GPLOCK_LOCK_SHIFT		4
-
-/*
- * BSEC_OTP_STATUS Register
- */
-#define BSEC_MODE_STATUS_MASK		GENMASK(2, 0)
-#define BSEC_MODE_BUSY_MASK		BIT(3)
-#define BSEC_MODE_PROGFAIL_MASK		BIT(4)
-#define BSEC_MODE_PWR_MASK		BIT(5)
-#define BSEC_MODE_BIST1_LOCK_MASK	BIT(6)
-#define BSEC_MODE_BIST2_LOCK_MASK	BIT(7)
-
-/* OTP MODE*/
-#define BSEC_MODE_OPEN1			0x00
-#define BSEC_MODE_SECURED		0x01
-#define BSEC_MODE_OPEN2			0x02
-#define BSEC_MODE_INVALID		0x04
-
-/* BSEC_DENABLE Register */
-#define BSEC_HDPEN			BIT(4)
-#define BSEC_SPIDEN			BIT(5)
-#define BSEC_SPINDEN			BIT(6)
-#define BSEC_DBGSWGEN			BIT(10)
-#define BSEC_DEN_ALL_MSK		GENMASK(10, 0)
-
-/* BSEC_FENABLE Register */
-#define BSEC_FEN_ALL_MSK		GENMASK(14, 0)
-
-/*
- * OTP Lock services definition
- * Value must corresponding to the bit number in the register
+ * OTP Lock services definition.
+ * Value must corresponding to the bit number in the register.
+ * Special case: (bit number << 1) for BSEC3.
  */
 #define BSEC_LOCK_UPPER_OTP		0x00
+#define BSEC_LOCK_GWLOCK		0x01
 #define BSEC_LOCK_DEBUG			0x02
 #define BSEC_LOCK_PROGRAM		0x03
+#define BSEC_LOCK_KVLOCK		0x04
 
-/* Values for struct bsec_config::freq */
+/*
+ * Values for struct bsec_config::freq
+ */
 #define FREQ_10_20_MHZ			0x0
 #define FREQ_20_30_MHZ			0x1
 #define FREQ_30_45_MHZ			0x2
@@ -146,22 +63,28 @@
 
 /*
  * Device info structure, providing device-specific functions and a means of
- * adding driver-specific state
+ * adding driver-specific state.
  */
 struct bsec_config {
+	uint8_t den_lock;	/*
+				 * Debug enable sticky lock
+				 * 1 debug enable is locked until next reset
+				 */
+
+	/*  BSEC2 only */
 	uint8_t tread;		/* SAFMEM Reading current level default 0 */
 	uint8_t pulse_width;	/* SAFMEM Programming pulse width default 1 */
-	uint8_t freq;		/* SAFMEM CLOCK see freq value define
+	uint8_t freq;		/*
+				 * SAFMEM CLOCK see freq value define
 				 * default FREQ_45_67_MHZ
 				 */
 	uint8_t power;		/* Power up SAFMEM. 1 power up, 0 power off */
-	uint8_t prog_lock;	/* Programming Sticky lock
+	uint8_t prog_lock;	/*
+				 * Programming Sticky lock
 				 * 1 programming is locked until next reset
 				 */
-	uint8_t den_lock;	/* Debug enable sticky lock
-				 * 1 debug enable is locked until next reset
-				 */
-	uint8_t upper_otp_lock;	/* Shadowing of upper OTP sticky lock
+	uint8_t upper_otp_lock;	/*
+				 * Shadowing of upper OTP sticky lock
 				 * 1 shadowing of upper OTP is locked
 				 * until next reset
 				 */
@@ -179,10 +102,11 @@
 uint32_t bsec_program_otp(uint32_t val, uint32_t otp);
 uint32_t bsec_permanent_lock_otp(uint32_t otp);
 
-uint32_t bsec_write_debug_conf(uint32_t val);
+void bsec_write_debug_conf(uint32_t val);
 uint32_t bsec_read_debug_conf(void);
-uint32_t bsec_write_feature_conf(uint32_t val);
-uint32_t bsec_read_feature_conf(uint32_t *val);
+
+void bsec_write_scratch(uint32_t val);
+uint32_t bsec_read_scratch(void);
 
 uint32_t bsec_get_status(void);
 uint32_t bsec_get_hw_conf(void);
@@ -190,14 +114,14 @@
 uint32_t bsec_get_id(void);
 uint32_t bsec_get_magic_id(void);
 
-bool bsec_write_sr_lock(uint32_t otp, uint32_t value);
-bool bsec_read_sr_lock(uint32_t otp);
-bool bsec_write_sw_lock(uint32_t otp, uint32_t value);
-bool bsec_read_sw_lock(uint32_t otp);
-bool bsec_write_sp_lock(uint32_t otp, uint32_t value);
-bool bsec_read_sp_lock(uint32_t otp);
-bool bsec_wr_lock(uint32_t otp);
-uint32_t bsec_otp_lock(uint32_t service, uint32_t value);
+uint32_t bsec_set_sr_lock(uint32_t otp);
+uint32_t bsec_read_sr_lock(uint32_t otp, bool *value);
+uint32_t bsec_set_sw_lock(uint32_t otp);
+uint32_t bsec_read_sw_lock(uint32_t otp, bool *value);
+uint32_t bsec_set_sp_lock(uint32_t otp);
+uint32_t bsec_read_sp_lock(uint32_t otp, bool *value);
+uint32_t bsec_read_permanent_lock(uint32_t otp, bool *value);
+uint32_t bsec_otp_lock(uint32_t service);
 
 uint32_t bsec_shadow_read_otp(uint32_t *otp_value, uint32_t word);
 uint32_t bsec_check_nsec_access_rights(uint32_t otp);