v4.19.13 snapshot.
diff --git a/include/linux/pinctrl/pinctrl-state.h b/include/linux/pinctrl/pinctrl-state.h
new file mode 100644
index 0000000..a0e7858
--- /dev/null
+++ b/include/linux/pinctrl/pinctrl-state.h
@@ -0,0 +1,33 @@
+/* SPDX-License-Identifier: GPL-2.0 */
+/*
+ * Standard pin control state definitions
+ */
+
+/**
+ * @PINCTRL_STATE_DEFAULT: the state the pinctrl handle shall be put
+ * into as default, usually this means the pins are up and ready to
+ * be used by the device driver. This state is commonly used by
+ * hogs to configure muxing and pins at boot, and also as a state
+ * to go into when returning from sleep and idle in
+ * .pm_runtime_resume() or ordinary .resume() for example.
+ * @PINCTRL_STATE_INIT: normally the pinctrl will be set to "default"
+ * before the driver's probe() function is called. There are some
+ * drivers where that is not appropriate becausing doing so would
+ * glitch the pins. In those cases you can add an "init" pinctrl
+ * which is the state of the pins before drive probe. After probe
+ * if the pins are still in "init" state they'll be moved to
+ * "default".
+ * @PINCTRL_STATE_IDLE: the state the pinctrl handle shall be put into
+ * when the pins are idle. This is a state where the system is relaxed
+ * but not fully sleeping - some power may be on but clocks gated for
+ * example. Could typically be set from a pm_runtime_suspend() or
+ * pm_runtime_idle() operation.
+ * @PINCTRL_STATE_SLEEP: the state the pinctrl handle shall be put into
+ * when the pins are sleeping. This is a state where the system is in
+ * its lowest sleep state. Could typically be set from an
+ * ordinary .suspend() function.
+ */
+#define PINCTRL_STATE_DEFAULT "default"
+#define PINCTRL_STATE_INIT "init"
+#define PINCTRL_STATE_IDLE "idle"
+#define PINCTRL_STATE_SLEEP "sleep"