Update Linux to v5.4.2
Change-Id: Idf6911045d9d382da2cfe01b1edff026404ac8fd
diff --git a/include/linux/regulator/fixed.h b/include/linux/regulator/fixed.h
index 48918be..d44ce5f 100644
--- a/include/linux/regulator/fixed.h
+++ b/include/linux/regulator/fixed.h
@@ -1,3 +1,4 @@
+/* SPDX-License-Identifier: GPL-2.0-or-later */
/*
* fixed.h
*
@@ -7,11 +8,6 @@
*
* Copyright (c) 2009 Nokia Corporation
* Roger Quadros <ext-roger.quadros@nokia.com>
- *
- * This program is free software; you can redistribute it and/or
- * modify it under the terms of the GNU General Public License as
- * published by the Free Software Foundation; either version 2 of the
- * License, or (at your option) any later version.
*/
#ifndef __REGULATOR_FIXED_H
@@ -24,17 +20,7 @@
* @supply_name: Name of the regulator supply
* @input_supply: Name of the input regulator supply
* @microvolts: Output voltage of regulator
- * @gpio: GPIO to use for enable control
- * set to -EINVAL if not used
* @startup_delay: Start-up time in microseconds
- * @gpio_is_open_drain: Gpio pin is open drain or normal type.
- * If it is open drain type then HIGH will be set
- * through PULL-UP with setting gpio as input
- * and low will be set as gpio-output with driven
- * to low. For non-open-drain case, the gpio will
- * will be in output and drive to low/high accordingly.
- * @enable_high: Polarity of enable GPIO
- * 1 = Active high, 0 = Active low
* @enabled_at_boot: Whether regulator has been enabled at
* boot or not. 1 = Yes, 0 = No
* This is used to keep the regulator at
@@ -49,10 +35,7 @@
const char *supply_name;
const char *input_supply;
int microvolts;
- int gpio;
unsigned startup_delay;
- unsigned gpio_is_open_drain:1;
- unsigned enable_high:1;
unsigned enabled_at_boot:1;
struct regulator_init_data *init_data;
};