Update Linux to v5.4.2
Change-Id: Idf6911045d9d382da2cfe01b1edff026404ac8fd
diff --git a/drivers/usb/common/Kconfig b/drivers/usb/common/Kconfig
new file mode 100644
index 0000000..d611477
--- /dev/null
+++ b/drivers/usb/common/Kconfig
@@ -0,0 +1,51 @@
+# SPDX-License-Identifier: GPL-2.0
+
+config USB_COMMON
+ tristate
+
+
+config USB_LED_TRIG
+ bool "USB LED Triggers"
+ depends on LEDS_CLASS && LEDS_TRIGGERS
+ select USB_COMMON
+ help
+ This option adds LED triggers for USB host and/or gadget activity.
+
+ Say Y here if you are working on a system with led-class supported
+ LEDs and you want to use them as activity indicators for USB host or
+ gadget.
+
+config USB_ULPI_BUS
+ tristate "USB ULPI PHY interface support"
+ select USB_COMMON
+ help
+ UTMI+ Low Pin Interface (ULPI) is specification for a commonly used
+ USB 2.0 PHY interface. The ULPI specification defines a standard set
+ of registers that can be used to detect the vendor and product which
+ allows ULPI to be handled as a bus. This module is the driver for that
+ bus.
+
+ The ULPI interfaces (the buses) are registered by the drivers for USB
+ controllers which support ULPI register access and have ULPI PHY
+ attached to them. The ULPI PHY drivers themselves are normal PHY
+ drivers.
+
+ ULPI PHYs provide often functions such as ADP sensing/probing (OTG
+ protocol) and USB charger detection.
+
+ To compile this driver as a module, choose M here: the module will
+ be called ulpi.
+
+config USB_CONN_GPIO
+ tristate "USB GPIO Based Connection Detection Driver"
+ depends on GPIOLIB
+ select USB_ROLE_SWITCH
+ help
+ The driver supports USB role switch between host and device via GPIO
+ based USB cable detection, used typically if an input GPIO is used
+ to detect USB ID pin, and another input GPIO may be also used to detect
+ Vbus pin at the same time, it also can be used to enable/disable
+ device if an input GPIO is only used to detect Vbus pin.
+
+ To compile the driver as a module, choose M here: the module will
+ be called usb-conn-gpio.ko